User Manual
Table Of Contents
- Contents
- Live With Safety
- Parts List
- Service Parts
- Parts Included In Kit
- Tools and Equipment
- Customer Support Center
- Customer Personal Service (CPS)
- Cellular Service
- Basic System Layout
- Selecting Mounting Location For Communications Controller
- Installing Communications Controller
- _
- Removing Communications Controller
- Installing Communications Controller Harness
- Installing Power Harness
- Selecting Mounting Location For Antennas
- Assembling Antennas Using Mounting Bracket
- Installing Antennas Through Machine Roof or Metal Panel
- System Testing
- Vehicle Hours Synchronization
- Problem Diagnosis
- Page Numbers
Installation Instructions
CED,TX13067,2460 –19–03AUG99–2/3
T129751B –UN–30MAR00
1—Fuse
2—Cover
2. Remove the cover (2) and W+/R+ Engine Running
Fuse (1) from the Power Harness. This fuse has
Purple wires going to it.
3. Key ON.
4. Observe CELL and GPS/ENG RUN LED Light as
ignition key is turned ON. Both LED lights must be ON
for 1—5 seconds indicating power to the
communications controller. LED lights may go OFF
indicating no cellular service or GPS lock.
5. The system will now test CELL and GPS functionality.
Both LED lights will come ON indicating successful
completion of this test. This may take 10 minutes.
CED,TX13067,2460 –19–03AUG99–3/3
T127603B –UN–22JAN00
1—Communications Controller
2—GPS Antenna Cable
3—GPS/ENG RUN LED Light
6. Carefully remove GPS antenna cable (2) from
communications controller (1). The GPS/ENG RUN
LED Light (3) should go OFF to indicate No GPS lock.
7. Replace W+/R+ Engine Running Fuse and cover.
8. With GPS antenna cable disconnected, start engine.
Within 10 seconds GPS/ENG RUN LED light must
come ON and stay ON indicating the engine is running.
9. Stop engine. Connect GPS antenna cable.
System is OK.
DeereTrax (13APR00)
35
Installation Instructions
041300
PN=37
P R O O F P R O O F