User Manual
Table Of Contents
- Contents
- Live With Safety
- Parts List
- Service Parts
- Parts Included In Kit
- Tools and Equipment
- Customer Support Center
- Customer Personal Service (CPS)
- Cellular Service
- Basic System Layout
- Selecting Mounting Location For Communications Controller
- Installing Communications Controller
- _
- Removing Communications Controller
- Installing Communications Controller Harness
- Installing Power Harness
- Selecting Mounting Location For Antennas
- Assembling Antennas Using Mounting Bracket
- Installing Antennas Through Machine Roof or Metal Panel
- System Testing
- Vehicle Hours Synchronization
- Problem Diagnosis
- Page Numbers
Installation Instructions
CED,TX13067,2664 –19–02FEB00–1/1
Removing Communications Controller
1. To remove the communications controller after
installing with the hook and hook fastener:
a. Carefully pry controller from mounting surface
starting at a corner.
b. To prevent hook and hook fastener from pulling
away from controller, push your finger between the
fastener pieces.
c. If hook and hook fastener pulls loose from the
controller, press it back in place.
2. To reinstall the controller:
a. Align hook and hook fastener strips on controller
and mounting surface, then press controller against
one end of the fastener strips and “rock” into full
contact.
b. Slowly apply pressure along full length of controller
until fasteners are secure.
3. If additional hook and hook fastener strips, alcohol
wipes or primer is needed, order VCA10039 Hook and
Hook Fastener Kit.
DeereTrax (13APR00)
20
Installation Instructions
041300
PN=22
P R O O F P R O O F