Instruction Manual

Installation Instruction
CED,TX13067,2664 –19–02FEB00–1/1
REMOVING COMMUNICATIONS
CONTROLLER
1. To remove the communications controller after
installing with the hook and hook fastener:
a. Carefully pry controller from mounting surface
starting at a corner. To prevent hook and hook
fastener from pulling away from controller, push
your finger between the fastener pieces.
b. If hook and hook fastener pulls loose from the
controller, press it back in place.
2. To reinstall the controller, align hook and hook fastener
strips on controller and mounting surface, then press
controller against one end of the fastener strips and
“rock” into full contact.
Slowly apply pressure along full length of controller
until fasteners are secure.
DeereTrax (03FEB00)
19
Installation Instruction
020300
PN=21