Instruction Manual

Installation Instruction
CED,TX13067,2458 –19–03AUG99–1/1
SELECTING MOUNTING LOCATION FOR
COMMUNICATIONS CONTROLLER
T127567B –UN–22JAN00
IMPORTANT: Before doing any work on an electrical
component, turn battery disconnect
switch OFF or disconnect negative
battery cable. Damage to electrical
components may result if terminals are
shorted during maintenance.
Never install close to the engine,
transmission or hydraulic tank where
temperature may exceed 70°C (160°F).
Never install on a panel that vibrates
excessively. Controller damage may
result if exposed to excessive heat or
vibration.
• Install communications controller in a protected area
where it won’t be exposed to excessive heat or damage
from chains or tools carried in the cab. The load center
area of a 4-wheel drive loader is an ideal location.
• Avoid installation in areas where temperature can
exceed 70°C (160°F). Typical areas to avoid are inside
the engine compartment, next to a hydraulic tank or
transmission.
• Select a location so harness connectors and antenna
cables can be attached or removed easily.
• Do not install in a location that will prevent removal of
other components.
• Install controller horizontally or with connectors down to
prevent water or oil from collecting in harness
connections.
• Before final location is chosen, check power harness
length and antenna cable length.
DeereTrax (03FEB00) 15 Installation Instruction
020300
PN=17