Installation & Assembly
3601 S. Banker St. Effingham, IL 62401 • P.O. BOX 609 • Ph: (888) 431-2667 • Fax: (800) 433-2667
sales@johnboos.com
www.johnboos.com
ASSEMBLY INSTRUCTIONS
FOR FOUNDRY COLLECTION
TABLES
PARTS:
(1) TABLE TOP
(1) STRINGER
(2) TABLE LEGS
HARDWARE (PER LEG):
(10) 1/4" X 1-1/4" HEX HEAD WOOD SCREWS
(8) 1/4" WASHERS
TOOLS REQUIRED:
- 3/8" SOCKET
CAUTION:
MAKE CERTAIN ASSISTANCE IS AVAILABLE WHEN SETTING TABLE UPRIGHT TO AVOID INJURY TO YOURSELF OR THE TABLE.
INSTRUCTIONS:
- ALLOW AMPLE ROOM FOR ASSEMBLY IN CLOSE PROXIMITY TO WHERE PRODUCT WILL BE PLACED
- CHECK ALL OF THE PARTS AND QUANTITIES ARE INCLUDED BEFORE ASSEMBLY. CONTACT CUSTOMER SERVICE FOR
MISSING PARTS.
- IDENTIFY ALL OF THE PARTS, HARDWARE, AND QUANTITIES REQUIRED FOR EACH STEP
- DO NOT USE POWER TOOLS TO ASSEMBLE THIS PRODUCT, DO NOT OVER-TIGHTEN ANY FITTINGS.
1. REMOVE ALL PACKAGING MATERIAL FROM THE CARTON.
2. REFER TO PARTS LIST AND HARDWARE LIST AND ENSURE THEY ARE COMPLETE BEFORE YOU
START ASSEMBLING.
3. PLACE WOOD TOP TABLE FACE DOWN ON A CLEAN, SOFT FLAT SURFACE (CARPET/RUG) TO PREVENT WOOD TABLE TOP
FROM GETTING SCRATCHED.
4. WITH THE TABLE LAYING ON ITS TOP, ALIGN HOLES IN TABLE LEG WITH PREDRILLED HOLES IN
WOOD TABLE TOP.
5. SECURE THE LEGS TO THE WOOD TOP USING (8) 1/4" X 1-1/4" HEX HEAD WOOD SCREWS, (8) 1/4" WASHERS, AND A 3/8"
SOCKET
6. ONCE BOTH LEGS ARE SECURED TO THE TOP, FLIP THE PARTIALLY ASSEMBLED TABLE OVER AND STAND IT UPRIGHT
7. ALIGN HOLES IN STRINGER WITH HOLES IN THE BASE AND SECURE USING (2) 1/4" X 1-1/4" HEX
HEAD WOOD SCREWS.
011020