Owner's Manual
13
Joerns® Bed Frames
WeCare™ Bed
© 2021 Joerns Healthcare • 6110429 RevC • 21-2257
Accessories
Accessory Weights
Warning: Possible Injury Or Death.
Baseboard Bumper
Recommended Tool: Rubber mallet
1.
2.
Mattress Stops
Warning: Possible Injury.
used with mattress that compresses to less than 1.5
inches under load.
Warning: Possible Injury.
the entire width between side stops. Failure to do so
Tools Required: #2 Phillips screwdriver
1. Locate the screws at each corner of the inside
tube at the foot end of the screws mattress support
2. Remove the screws using the #2 Phillips
screwdriver; do not discard the screws.
3. Position and insert the mattress stops in the
removed in step 2.
4. Locate the screws in the holes in each corner of
the inside tube at the head end of the mattress
support platform; one per side.
5. Remove the screws using the #2 Phillips
screwdriver; do not discard the screws.
6. Position and insert the mattress stops in the holes
provided. Reinstall the screws removed in step 5.
Figure 24
Figure 23
Figure 25
Figure 26