User Manual

Joerns® Bed Frames

WeCare™ Bed

Installation Of Head and Foot Panels

Refer to Bed Panel Installation Sheet for more

Tools required: #2Phillips screwdriver

Head Panel Installation:

1. Head panel has label on back.

2. Lay panel on soft surface front face down.

3. Head panel brackets are longer of two sizes

(Figure 19).

4. Install head panel brackets with four screws

provided. Bracket o󰀨set should face up (Figure

20). Do not tighten until after tting mounting

brackets into bed sockets.

5. Go to nal assembly below.

Frame-Mounted Foot Panel Installation:

1. Foot panel does not have label on back. Foot

panel will have sta󰀨 control electronics, if sta󰀨

control was ordered.

2. Lay panel on soft surface front face down.

3. Foot panel brackets are shorter of two sizes

(Figure 19).

4. Install the foot panel brackets with four screws

provided. Bracket o󰀨set should face up (Figure 20)

Do not tighten until after tting mounting brackets

into bed sockets.

5. For foot panel with optional sta󰀨 control, refer to

next page for install instructions and cable routing.

6. Go to nal assembly below.

Final Assembly Step for Head Panel and Frame-

Mounted Foot Panel:

1. Insert head and foot panel as shown with

mounting hardware facing head of the bed

(Figure 21).

2. Tighten all screws with panels in place.

3. Panels should slip in and out of their sockets

easily and securely.

Figure 19

Head Panel

Bracket-10.5"

Foot Panel

Bracket-6.9"

O󰀨set facing up

Figure 20

Figure 21