User Manual

Joerns® Bed Frames

WeCare™ Bed

6. Line up back and knee actuators and insert

actuator pin then add clip to lock in place (Figure 7

and 8). Ensure the washers are used on the back

actuator (Figure 9).

7. Locate back actuator and head end hi-lo cables

and route through safety pin bail (Figure 6), then

route behind cable bundle (Figure 10 and 11).

8. Insert back actuator cable in port 1 and insert hi-lo

actuator head end cable in port 3 (Figure 12).

9. Secure cables with cable clamp (Figure 13).

10. Route power cord in grey clips to head end.

Plug-in power cord to power source and raise the

bed frame.

Note: Watch for obstructions.

Figure 7

Figure 8

Figure 10

Figure 11

Figure 12

Figure 13Figure 9