Instruction Manual

ManualsBrandsJoda ManualsSauna RoomJoda KX-904VS 4-Person Hemlock Sauna Room

FAR INFRARED SAUNA OPERATING INSTURCTIONS

Please read all instructions carefully before using the products

KX-904VS

PRECAUTIONS AND INST RU CT ION S ................................................................1

INSTALLATION GUIDE..............................................................................................3

CONTROL PANEL INSTRUCTION.............................................................................6

SPECIFICATION...........................................................................................................6

Summary of content (7 pages)

PAGE 1
FAR INFRARED SAUNA OPERATING INSTURCTIONS Please read all instructions carefully before using the products KX-904VS PRECAUTIONS AN D IN S T R U C T I O N S ................................................................1 INSTALLATION GUIDE..............................................................................................3 CONTROL PANEL INSTRUCTION.............................................................................6 SPECIFICATION..........................................................
PAGE 2
Precautions and Instructions ATTENTION Please read all instructions thoroughly before using. Serious injury may result if ignore the following warning and instruction. Basic precautions should always be followed when using this electrical equipment. DANGER To avoid the risk of causing burns, fire, electric shock, or other injuries:  Connect the power cord to a properly grounded outlet.  Using only for its intended use as described in this manual.
PAGE 3
a) Failure to perceive heat / Unawareness of impending heat b) Failure to recognize the need to exit the sauna c) Fetal damage in pregnant women d) Physical inability to exit the sauna e) Unconsciousness Installation Guide Each panel is heavy, especially the top panel. Be careful to avoid injury when installing. This sauna requires at least 2 adults to complete assembly. There is a (+) button and a (–) button at the sides of each panel.
PAGE 4
Installation of the Sauna Room Body 1. Place the floor panel on a flat surface (Note: Before installing wall and ceiling panels, make sure the floor is flat. If the surface is not flat, you may need shims to achieve a flat surface.) (Picture 1).(Picture2) 2. Snap the groove of the back panel into the tenons of the floor panel.(Picture3) 3. Place the side panel into the tenons of the floor panel, and make it fit into the back panel.(Picture4) 4.
PAGE 5
. Clip the groove of the Bench Support panel into the tenons on both sides and connect the wires behind. (Picture 6&7） 6. Place the Bench surface panel. (Picture 8) Bench support panel Picture 6 Picture 5 Presentation Picture 7 7. Top panel fixed and wire connection.  Make sure all side panels are in the slot of top panel, make sure all wires from side panels are not pressed in the slot.  Make sure that all wires in the top panel are connected.
PAGE 6
8. Plug in and power on to operate the sauna room WARNING: Pay attention to the risk of electric shock. Don’t connect the power supply until all wires are properly connected.
PAGE 7
Control Panel Instruction Simultaneous operation can be converted to Fahrenheit Switch on or off the sauna room. Time adjust (01-60mins) Temp adjust (25-65℃) Switch on or off the light inside sauna room. Switch on or off the color lights in the sauna room. Specification Product Name Model No.