User Manual

TEMPERATURE CONTROL
PRECAUTIONS
TECHNICAL SPECIFICATIONS
Model JEXP210-003379
Rated Voltage 220-240V
Nominal frequency (Hz) 50Hz
Net capacity (liters) 210
Net / gross weight (Kg) 54/59
Dimensions HxWxD (mm) 1820 X 512 X 495
Temperature: De -1 a 10ºC
Gas R600a/42g
- 10 -
Beverage Cooler temperature is controlled by adjusting the thermostat, which is located inside.
1. The temperature inside the Showcase is regulated by the Thermostat, turning the key clockwise.
The larger the figure, the lower the temperature. Normally, the “3-4” position is adequate. The
“MAX” position makes the product work continuously. The “MIN” position switches the Beverage
Cooler off.
1. Remove all packaging before using the Showcase. Do not tilt it more than 60° when carrying it.
2.
The Beverage Cooler must be installed in a place with good ventilation, cool, dry and free from
corrosive gases. It should not be placed near heat sources or in direct sunlight. A free space grea-
ter than 10cm must be left between the wall and the product. Upon installation, the universal
wheels must be well inflated so that the Showcase is level and stable. Otherwise it can cause
vibration and make a lot of noise.
3. When using it for the first time, the product should work empty for about an hour.
4. To save energy, the door should not be opened too often or kept open for a long time.
5. The surface and interior of the Showcase must be clean and dry. Prolonged humidity causes
the Display to rust slowly.
6. It is recommended that the Showcase be cleaned periodically. Usually every 30-45 days is best.
The interior and exterior surface of the product should be cleaned with a soft cloth and mild soap
or detergent.
Attention: To ensure safety, disconnect the plug from the socket before cleaning.