User's Manual

BTS400 Instruction Manual

SPECIFICATIONS

1. Power: 5 Watts

2. Frequency response： 95Hz-18KHz

3. Battery： 10000±20mAh

4. Playing Time： Fully charged battery lasts about 4-6 hours

5. Bluetooth™ Range： 8-10 Meters in an open area

6. Wireless Version: V2.1 + EDR

OPERATION

Power Button： Turn the speaker on by pressing the power button for 2 seconds. The speaker

says “hello” and then “start pairing”. To turn off, press the power button for 2 seconds and that

speaker will say “goodbye”. The ring on the top lights up while power is on.

Pause/Play：Press and release power button to pause\play. (Or control from the music player)

Line-In/AUX function: Connect the 3.5mm line into the headphone jack of your computer and Micro

USB plug into the speaker.

Next/Previous and Volume Up/Down: Use the “ ” ”keys to control theses function

in Bluetooth paired mode , or use the functions on you smart phone or music player to

control these functions when connected to pc/Laptop.

CHARGING

Plug the micro USB end of the charging cable into the charging port of the speaker and then connect

the USB end of the charging cable to the USB port of your PC or other USB power source. The red LED

will light up while charging (the small hole on the left corner of the micro USB ). The red LED

will turn off automatically when charging is complete. It is strongly recommended that the speaker be

fully charged before first use and after long periods of inactivity. Do not overcharge the battery.

PAGE 1
BTS400 Instruction Manual SPECIFICATIONS 1. Power: 2. Frequency response： 3. Battery： 4. Playing Time： 5. Bluetooth™ Range： 6. Wireless Version: 5 Watts 95Hz-18KHz 10000±20mAh Fully charged battery lasts about 4-6 hours 8-10 Meters in an open area V2.1 + EDR OPERATION Power Button： Turn the speaker on by pressing the power button for 2 seconds. The speaker says “hello” and then “start pairing”. To turn off, press the power button for 2 seconds and that speaker will say “goodbye”.
PAGE 2
WIRELESS PAIRING 1. Please check to make sure the device to which you are pairing has Bluetooth™ capabilities. This information should be included in your phone or music player’s instructions or packaging. 2. Make sure that the speaker is turned off, then place the speaker and the smart phone or music player in proximity so that both devices are in view. 3. Turn the speaker on using the power button. While waiting for the Bluetooth™ connection, red and blue lights flash (1.0 seconds per flash). 4.
PAGE 3
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. (5mm) This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.