User's Manual
Selfie key:
Short press and release: take photo in photo mode or increase volume of media
Long press: release alarm when enable an drop funcon, need to connect again
Volume” + “:
Short press and release: next and increase volume
Long press: increase volume
Volume” –“:
Short press and release: previous
Long press: decrease volume
CHARGING:
Plug the Micro USB end of the charging cable into the charging port of the speaker and then
connect the USB end of the charging cable to the USB port of your PC o
r other USB power source.
The red LED will light up while charging (the small hole on the le corner of the Micro USB). The
red LED will turn off automacally when charging is complete. It is strongly recommended that
the receiver be fully charged before first use and aer long periods of inacvity. Do not
overcharge the baery.
PRECAUTIONS
Please only use the computer USB or the DC 5V power adaptor matching the Micro USB
interface to charge. Only use quality cords and adaptors.
Please keep and use in normal environments. Exposure to extreme elements such as
extreme heat and cold, fire, excessive moisture, dust, or other extreme elements may
damage the unit. Do not touch with wet hands.
Keep debris or other items from blocking the speakers or fro
m entering any of the ports.
Do not aempt to open, repair, or take apart the speaker. The speaker may be damaged
during that process.
If the speaker quality seems lessened, or a slight popping noise is heard, it may be due to
low baery. Please recharge the speaker.
This item is not meant for children.
TROUBLESHOOTING
No Sound
Make sure that the music player is working and that the speaker is charged.
Make sure the Bluetooth™ is paired to the device you are aempng to play. (It could
automacally pair with another familiar device within pairing distance.)
Make sure the BTR500 is in the proper mode.
Not charging
Check to make sure that you are using the correct cable and that it is fully plugged into both the
device and the USB port that you are charging from. Also check to make sure the PC or other USB
charger is turned on.