Product Manual

ManualsBrandsJMS Sewage ManualsSewage + Trash PumpsJMS-USA Submersible Sewage Water Pump — 3660 GPH, 1.1 HP, Single-Phase

FAULT CHECK (possible cause) REMEDY

12 MODIFICATIONS AND SPARE PARTS

Any modication not authorized beforehand relieves the manufacturer of all responsibility.

All the spare parts used in repairs must be original JMS. For codes and denominations see

enclosed sheet.

All accessories must be approved by the manufacturer so as to be able to ensure maximum

safety of the machines and systems in which they may be tted.

13 TROUBLESHOOTING

1.The motor does not

start and makes no

noise.

A.Make sure motor is live and

check that the mains voltage cor-

responds to the one on the data

plate.

B.Check the protection fuses.

C.The oat switch prevents

starup.

D.The shaft is not turning.

D. Turn the shaft as indicated in

the Warnings chapter

(Paragraph 6.3. ).

2.The pump does not

deliver.

A.The pipes are obstructed.

B.The impellers are worn or blo-

cked.

C.The uid level is too low.

On starting, the water level must

be higher than the lter level.

D.The head required is higher

than thepump’s characteristics

A.Remove the obstructions, as

indicated in the Warnings

chapter (Paragraph 6.4).

3.The pump does not

stop.

A. The oat does not interrupt

the operating of the pump.

A. Make sure oat moves freely

and check its efcient.

In any case, all repair and maintenance jobs must be carried out only after having disconnected

the pump from the power mains, once made sure that it cannot suddenly begin working.During

dismantling it is necessary to pay great attention to sharp parts which may cause injury.The cut-

ting edge ange of the electropump is provided of aspiration fans. It is advisable, every now and

then, to clean these fans to avoid a loss of efciency. Best cleaning is obtained through a throw

of water. Sand and other abrasive materials cause precocious wear and tear, as well as loss of

performances.

B. If they are burnt-out, change

them.

C. Make sure oat moves freely and

check its efciency.

B.Change the impellers or remove

the obstruction.

C.Regulate the length of the

oat switch cable (See chap

ter on Warnings - Paragraph

9.2.)