Thank you for purchasing GoChef™ 8 in 1 Cooker from JML. To get the best results from this cooker, please read these instructions in full and keep them safe for future reference.
Safety Warnings & Advice GENERAL • Keep out of the reach of children. • This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or a lack of experience and knowledge if they have been given supervision or instruction concerning the use of this appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Safety Warnings & Advice ENVIRONMENT • Only use on a safe, stable, heat-proof work surface, away from water or water splashes. Ensure the area immediately around the Cooker is free from clutter. • DO NOT allow the Power Cord or plug to fall in water or any other liquid; to hang over the edge of surfaces; or to touch any hot surfaces. • DO NOT place the GoChef™ Cooker on or near a hot gas or electric hob, or in a heated oven. • DO NOT use or store the GoChef™ Cooker in damp or humid conditions.
Safety Warnings & Advice • DO NOT touch hot surfaces (the Bowl and Lid) during or after use. Surfaces can remain hot even after the GoChef™ Cooker is switched off. Remove the Glass Lid carefully after cooking; do not touch the glass, only the handle. • DO NOT place paper, cardboard, plastic or other flammable materials in the Non-Stick Bowl. • DO NOT add water to hot oil. CARE & MAINTENANCE • Wait for the Non-Stick Bowl to cool down completely after operation, before cleaning or removing parts.
Your GoChef™ Cooker Glass Lid Pouring Lip Max Fill Line Non-Stick 5-Litre Bowl Temperature Dial Heat Light Power Light Timer Dial Power Base Power Cord Basket Handle Low Rack 5 High Rack Frying Basket
Your GoChef™ Cooker Before assembly 1. Remove all packaging, including the foam sheet under the Non-Stick Bowl. Dispose of all packaging responsibly using local recycling schemes. 2. Wash the Non-Stick Bowl, Glass Lid and accessories in warm, soapy water. Dry fully before use. See page 14 for full cleaning and care instructions. Setting up 1. Plug in the Non-Stick Bowl. - Locate the gold pins on the Bowl’s base.
GoChef™ Cooker Functions NOTE All temperatures and timings listed are for guidance purposes only. They may need adjusting according to food types, quantities and taste requirements. Always check food packaging/labels for food preparation instructions. IMPORTANT Never fill the Non-Stick Bowl higher than the Max Fill Line marked on the inside of the Bowl. DO NOT use sharp or metal utensils when stirring or serving food to avoid damaging the non-stick surface.
GoChef™ Cooker Functions Slow cook 110 – 140°C Max Fill Line Basic instructions 1. Place your food in the Non-Stick Bowl and cover it with liquid (water, stock, wine etc.) Make sure you don’t exceed the Max Fill Line. 2. Place on the Glass Lid and turn the temperature to 110 – 140°C. Avoid opening the Glass Lid until your food is cooked. 3. When finished, carefully remove your food. Wait for the GoChef™ Non-Stick Bowl to fully cool down.
GoChef™ Cooker Functions Boil 220 – 240°C Basic instructions Max Fill Line 1. Fill the bowl with water without going over the Max Fill Line. 2. Turn the temperature up to 220 – 240°C and turn on the GoChef™ Cooker. Once the water is boiling add the food and then lower the temperature to 120°C to simmer. 3. When finished, carefully remove your food. Wait for the GoChef™ Non-Stick Bowl to fully cool down. Use the Pouring Lip side of the Non-Stick Bowl to empty out the water from the Bowl.
GoChef™ Cooker Functions Bake 180 – 200°C Basic instructions Low Rack 1. Place the Low Rack into the Non-Stick Bowl and turn the temperature to 180 – 200°C. 2. Place your ingredients on the rack. Oven safe pans and dishes can be used on the Low Rack. 3. Place on the Lid and turn the power on. Warning Be careful removing the Low Rack after cooking as it will be very hot. To bake potatoes Place your potatoes on the Low Rack and set the temperature to 190°C for 60 – 80 minutes depending on their size.
GoChef™ Cooker Functions Roast 180 – 200°C Basic instructions Low Rack 1. Place the Low Rack into the Non-Stick Bowl and turn the temperature up to 180 – 200°C. 2. Place on the Lid and wait for the Heat Light to turn off. 3. Open the Glass Lid, place your food inside, then replace the Lid. Warning Be careful when adding food to the Bowl and when removing the Rack after cooking as they will be very hot.
GoChef™ Cooker Functions Sauté 160 – 180°C Basic instructions 1. Pour a small amount of oil into the Non-Stick Bowl and turn the temperature to 160 – 180°C. For larger quantities of food, the temperature may need to be increased. 2. Once the oil starts to sizzle, place your ingredients inside. 3. Sauté until the edges start to colour and brown. DO NOT use metal utensils to stir ingredients in the GoChef™ Non-Stick Bowl. Only use plastic or wooden utensils.
GoChef™ Cooker Functions Flash Frying 200 – 210°C Basic instructions Frying Basket Max Fill Line 1. Pour oil into the Non-Stick Bowl, filling about half way to the Max Fill Line. Turn the temperature to 200 - 210°C and turn on. 2. Place your ingredients inside the assembled Frying Basket and rest on the side of the NonStick Bowl, using the hook under the handle. 3. When the Heat Light turns off, unhook and carefully lower the Basket into the oil to cook for 30 – 60 seconds.
GoChef™ Cooker Functions Deep fry 180°C - continued 3. When the Heat Light turns off, unhook and carefully lower the Basket into the oil to cook. When you have finished, rest the basket on the side of the Non-Stick Bowl to allow oil to drip back into the Bowl. 4. When finished, wait for the GoChef™ Non-Stick Bowl and the oil in it to fully cool down. Use the Pouring Lip side of the Non-Stick Bowl to empty out the oil from the Bowl. Warning Do not exceed the Max Fill Line when adding oil to the Bowl.
Fuse & mains plug replacement (UK & Ireland only) This appliance is fitted with a BS 1363 13-amp plug. If you have to replace the fuse, only use those that are ASTA or BSI approved to BS 1362 and have a rated current of 13 amps. To change the fuse 1. Use a flat-head screwdriver to prise the cover off the fuse compartment. 2. Carefully remove the existing fuse. 3. Clip the new 13 amp fuse into place. 4. Clip the cover back firmly into place.
