Users Manual

MS-01 SOM
All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI.
Page 8
`
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed with 20 cm is maintained between the antenna and
users in mobile or fixed applications.
2) The Antenna for Module (MS-01) is Non-detachable and the maximum antenna
gain allowed for use with this device is 0.0 dBi.@2.4GHz band & 2.3dBi@5GHz band.
3) The transmitter module may not be co-located with any other transmitter or antenna.
4) OEM integrators Must demonstrate SAR test and meet compliance before end-
product with module (MS-01) marketed in portable application.
OEM integrators Must demonstrate Part 15B test and meet compliance before end-product
with module (MS-01) marketed.
List of applicable FCC rules
This module has been tested and found to comply with 15.247 and 15.407 requirements for
Modular Approval.
US Information
Name of the company: JLT Mobile Computers Inc.
Address of the company: 7402 West Detroit Street, Suite 150, Chandler,
AZ 85226, US, 27518
Contact: Eric Miller CEO
Phone number: 480-397-1214 (f)
General
The SOM module uses Dipole and IFA antenna to do EMC official test then antenna gain
and trace design, please refer to antenna information and antenna trace design.
Antenna Information
Antenna Type: Dipole
Antenna gain: 1.44dBi@2.4GHz and 2.16dBi@5GHz
AntennaType: IFA
Antenna gain: 0.0@2.4GHz and 2.3dBi@5GHz
Important Note
notice that any deviation(s) from the defined parameters of the antenna trace, as described
by the instructions, require that the host product manufacturer must notify to USI that they
wish to change the antenna trace design. In this case, a Class II permissive change
application is required to be filed by the USI, or the host manufacturer can take responsibility
through the change in FCC ID (new application) procedure followed by a Class II permissive
change application.