Product Manual

SECTION 3 - MACHINE OPERATION
3121742 – JLG Lift – 3-7
Entering/Exiting The Platform
DO NOT EXCEED MAXIMUM PLATFORM CAPACITY. MAXIMUM CAPACITY
INCLUDES PERSONNEL IN PLATFORM PLUS WEIGHT IN TOOL TRAY OR ANY
OTHER WEIGHT PLACED IN PLATFORM.
1. Always maintain “three point contact” with the
machine, using two hands and one foot or two feet
and one hand at all times during entry and exit.
2. Attach your lanyard to the lanyard attachment point in
the lower right hand corner of the Mast.
3. Make sure entry gate is closed behind you.
4. Once in the platform and the entry gate fully closed,
the platform is ready for the operation.
BEFORE OPERATING PLATFORM CHECK AROUND AND OVERHEAD FOR ANY
OBSTACLES OR PERSONNEL THAT MAY COME INTO CONTACT WITH MACHINE
WHILE ELEVATING OR LOWERING THE PLATFORM. IF NECESSARY, EXIT
MACHINE AND REPOSITION BEFORE PROCEEDING.
5. Before exiting the platform, be certain platform is fully
lowered.
Platform Controls
1. Check there are no overhead
obstructions before elevating
platform.
2. The enable button (1), this button
must be pressed and held in to
operate either the UP or DOWN
buttons on the control box.
3. Battery Charge Indicator (2)
shows the charge status of the
onboard battery.
4. Press Up arrow button (3) to
elevate the platform.
5. Press Down arrow button
(4) to lower the platform.
6. In case of uncontrolled platform elevation or descent,
press in the RED emergency stop button (5) to the OFF
position. Twist clockwise to RESET to the ON position.
CRUSHING HAZARD - BE AWARE OF DESCENDING PLATFORM WHEN LOWER-
ING THE PLATFORM. KEEP HANDS OR FEET OFF THE MAST ASSEMBLY AND
FROM UNDER THE PLATFORM.
1