Product Manual

SECTION 3 - MACHINE OPERATION

3121742 – JLG Lift – 3-5

Figure 3-4. Battery Charge Indicator

(Located near the top of the Platform Control Box)

If observing the charger LEDs, ensure the GREEN LED (front of

charger) illuminates. and stays lit.

The adjacent AMBER LED has three modes (see Figure 3-5.).

1. Rapid flash, indicates maximum charge rate. (Note,

when switching charger on, the amber light must

rapid flash. If not, there is a fault, check fuse and con-

nections).

2. Slow pulse, indicates slower charging.

3. Continuous illumination indicates float charge. Both

LEDs go “off” when fully charged.

The battery charger can be connected to the AC power supply

at any time or left for extended periods.

NOTICE

AC POWER SUPPLY CIRCUIT SHOULD BE PROTECTED WITH A BREAKER CIR-

CUIT. ONLY CHARGE BATTERY IN A WELL-VENTILATED AREA.

NOTE: The charger is fitted with a 15A automotive spade fuse

(blue). If the fuse has failed, the indicator lights will still

operate. The fuse may have failed if the battery is heavily

discharged and the motor is run when the charger is

switched on. In such an event, the fuse is simple to replace;

ensure battery disconnect is switched off and that the

positive RED battery cable is disconnected before

attempting to check or change fuse.

1. Green LED 2. Amber LED

Figure 3-5. Charger LEDs