Service Manual User guide

SECTION 6 - JLG CONTROL SYSTEM
3121262 – JLG Lift – 6-51
Table 6-7. Machine Diagnostics Parameters
Diagnostics
Submenu
(Displayed on
Analyzer 1
st
Line)
Parameter (Displayed
on Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2
nd
Line)
Description
DRIVE:
DRIVE FOR/REV XXX% Displays drive joystick direction & demand
STEER RIGHT/LEFT XXX% Displays steer switch direction & demand
4WS NORMAL/COOR/CRAB Displays status of four wheel steer input (Displayed if 4WS = 1)
BRAKES LOCKED/RELEASED Displays brake control system status
CREEP ACTIVE/NOT ACTIVE Displays pump pot creep switch status
CRP MODE ACTIVE/NOT ACT Displays creep mode status
QPRX1 ACTIVE/NOT ACTIVE Displays status of Q-Prox sensor in drive joystick (Displayed if
JOYSTICK TYPE = 1)
QPRX2 ACTIVE/NOT ACTIVE Displays status of Q-Prox sensor in drive joystick (Displayed if
JOYSTICK TYPE = 1)
TWO SPEED OP/CL Displays status of two speed switch input if selected model has
two speed.
2 speed mode ON/OFF Displays status of two speed valve if selected model has two
speed
high engine OP/CL Displays status of high engine switch
LT F ANG XX.X Displays status of left front steer angle (Displayed if MODEL
NUMBER = 7 or 8)
RT F ANG XX.X Displays status of right front steer angle (Displayed if MODEL
NUMBER = 7 or 8)
LT R ANG XX.X Displays status of left rear steer angle (Displayed if MODEL NUM-
BER = 7 or 8)
RT R ANG XX.X Displays status of right rear steer angle (Displayed if MODEL
NUMBER = 7 or 8)
DOS LIM sw OP/CL Displays status of Drive Orientation System limit switch. (Dis-
played if MODEL NUMBER = 7 or 8)
DOS O/R sw OP/CL Displays status of Drive Orientation Limit System override switch.
(Displayed if MODEL NUMBER = 7 or 8)