Service Manual User guide

SECTION 6 - JLG CONTROL SYSTEM
3121262 – JLG Lift – 6-25
FROM: MACHINE SETUP
MENU: CALIBRATIONS
CALIBRATIONS:
CALIBRATIONS:
STEER
UNLOCK BOOM
CALIBRATIONS: DRIVE
CALIBRATE
CALIBRATE
STEER?
CHECK SYSTEM?
CALIBRATE DRIVE?
CALIBRATIONS: LEVEL UP CRKPT
CALIBRATIONS: CALIBRATIONS: CALIBRATIONS: LEVEL DOWN CRKPT JIB LVL UP CRKPT JIB LVL DN CRKPT
CALIBRATE LEVEL UP CRACKPOINT?
CALIBRATE LEVEL CALIBRATE LEVEL CALIBRATE LEVEL DOWN CRACKPOINT? UP CRACKPOINT? DOWN CRACKPOINT?
CALIBRATIONS: MAIN LIFT CRKPT
CALIBRATIONS: MAIN TELE CRKPT
CALIBRATE MAIN LIFT CRACKPOINT?
CALIBRATE MAIN TELE CRACKPOINT?
CALIBRATIONS: TILT SENSOR
CALIBRATIONS: CALIBRATIONS: CALIBRATIONS: BOOM SENSORS JIB SENSORS LSS
POSITION 1: CHECK SYSTEM?
POSITION 1: POSITION 1: POSITION 1: CHECK SYSTEM? CHECK SYSTEM? CHECK SYSTEM?
CALIBRATIONS: CALIBRATIONS: DEUTZ SETUP: NONE AVAILABLE DEUTZ SETUP: DEUTZ SETUP: DEUTZ SETUP: DEUTZ SETUP: SETUP 1 SETUP 2 SETUP 3 SETUP 4
Figure 6-6. Analyzer Flow Chart - Calibrations (Software Version 7.X)
NOTE: The layout shown includes all possible analyzer screens. Please note that some screens may not be available depending upon machine con-
figuration.