Service Manual

SECTION 5 - MAST COMPONENTS

3121231 – JLG Lift – 5-11

9. Remove the cylinder/anchor block attach pin - snap

ring from the back of the top of mast section-2.

10. Remove the cylinder rod pin from the cylinder/chain

anchor block.

11. At the bottom of mast section-1, remove the cylinder

mount bolts, and mount reinforcement plates.

NOTE: If mount shims are installed, mark the mast and the

shim to which side the shims came out of for re-

installation.

12. Slide the lift cylinder and mount assembly out of the

bottom of mast section-1 and -2 and place on a suit-

able work surface.

Snap Ring Installation

1. Back of Mast Section-2 3. Pin and Snap Ring

2. Cyl./Chain Anchor Block 4. Cylinder Rod

Cylinder Rod Pin Installation

1. Cylinder Rod Pin 3. Cyl./Chain Anchor Block

2. Cylinder Rod

Lift Cylinder Mount Installation

1. Cylinder/Mount Assembly 3. Mast Reinforcement Plate

2. Mount Shims (Mark Shims) 4. Mounting Screws/Washers (a)

Notes: (a) Apply Loctite #242 to threads at final assembly.