Operator Manual User Manual

TABLE OF CONTENTS
3121230 – JLG Lift – iii
SECTION - PARAGRAPH, SUBJECT PAGE SECTION - PARAGRAPH, SUBJECT PAGE
Hanging a Rug using the Rug Carrier
Accessory Arms . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-41
Removing a Rug using Rug Carrier
Accessory Arms. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-43
3.15 STOCK-PICKER HANGER ACCESSORY. . . . . . . . . . 3-45
Pre-Start Inspection . . . . . . . . . . . . . . . . . . . . . . . . . 3-45
Loading and Transporting an Item
using the Hanger Accessory . . . . . . . . . . . . . . . . . . 3-45
SECTION - 4 - EMERGENCY PROCEDURES
4.1 GENERAL INFORMATION . . . . . . . . . . . . . . . . . . . . . . 4-1
4.2 EMERGENCY OPERATION . . . . . . . . . . . . . . . . . . . . . 4-1
Operator Unable to Control Machine . . . . . . . . . . . . 4-1
Platform Caught Overhead . . . . . . . . . . . . . . . . . . . . 4-1
4.3 INCIDENT NOTIFICATION . . . . . . . . . . . . . . . . . . . . . . 4-1
SECTION - 5 - GENERAL SPECIFICATIONS AND OPERATOR
MAINTENANCE
5.1 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
5.2 GENERAL SPECIFICATIONS. . . . . . . . . . . . . . . . . . . . 5-2
Machine Specifications . . . . . . . . . . . . . . . . . . . . . . . 5-2
Machine Wheel Loads and PSI - Per Wheel . . . . . . . 5-4
Electrical Specifications. . . . . . . . . . . . . . . . . . . . . . . 5-6
Platform Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-7
Machine Component Weights . . . . . . . . . . . . . . . . . 5-8
Serial Number Locations . . . . . . . . . . . . . . . . . . . . . 5-8
5.3 OPERATOR MAINTENANCE . . . . . . . . . . . . . . . . . . . .5-9
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-9
Tires and Wheels . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-9
Lubrication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-11
5.4 GROUND CONTROL STATION -
PROGRAMMING5-14
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-14
Programming Levels . . . . . . . . . . . . . . . . . . . . . . . 5-14
Operator Programming Mode . . . . . . . . . . . . . . . . 5-14
Activating Programming Mode . . . . . . . . . . . . . . . 5-17
Entering Password . . . . . . . . . . . . . . . . . . . . . . . . . 5-18
Programming Mode Selection . . . . . . . . . . . . . . . . 5-18
Selecting Programmable Item to Adjust . . . . . . . . 5-19
Adjusting Programmable Setting. . . . . . . . . . . . . . 5-19
5.5 DRIVE MOTOR BRUSH WEAR -
WARNING INDICATION . . . . . . . . . . . . . . . . . . . . . . .5-20
5.6 SUPPLEMENTAL INFORMATION. . . . . . . . . . . . . . . .5-21
SECTION - 6 - INSPECTION AND REPAIR LOG