Operator Manual User Manual

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION

3-40 – JLG Lift – 3121230

Pre-Start Inspection

1. Electronic Module LED Indicator (a)

2. Detection Zone

3. Place a pad of paper or similar size object, 6

to 12 in. (15 to 30cm) individually beneath

each transducer to check detection.

NOTE: (a) The LED Indicator will flash when an

object is detected at each sensor. Remove

object and allow the LED to stop flashing

before testing next sensor.

Figure 3-10. OSS - Pre-Start Inspection of Operation.