Operator Manual User Manual

SECTION 1 - SAFETY PRECAUTIONS
3121230 – JLG Lift – 1-3
1.3 OPERATION
General
• Do not use the machine for any purpose other than posi-
tioning personnel, their tools and equipment, or for hand
stock picking.
• Never operate a machine that is not working properly. If a
malfunction occurs, shut down the machine.
• Never slam a control switch or lever through neutral to an
opposite direction. Always return switch to neutral and
stop before moving the switch to the next function. Oper-
ate controls with slow and even pressure.
• Do not allow personnel to tamper with or operate the
machine from the ground with personnel in the platform,
except in an emergency.
• Do not carry materials directly on platform railing unless
approved by JLG.
• Always ensure that power tools are properly stowed and
never left hanging by their cord from the platform work
area.
• Fully lower mast assembly and shut off all power before
leaving machine.
• When performing welding operations at elevation, precau-
tions must be taken to protect all machine components
from contact with weld splatter or molten metal.
• Battery fluid is highly corrosive. Avoid contact with skin
and clothing at all times.
• Charge batteries on in a well ventilated area.
Trip and Fall Hazard
• JLG Industries, Inc. recommends that the operator in the
platform wear approved fall protection attached to an
authorized lanyard anchorage point. Reference “Stock-
Picking Platform Operation” on page 28 for fall protection
requirements applicable to stockpicker platforms oper-
ated with the rails in the open position. For further informa-
tion regarding fall protection requirements on JLG
products, contact JLG Industries, Inc.