Service Manual Manual

SECTION 6 - JLG CONTROL SYSTEM
6-36 – JLG Lift – 3121142
Table 6-5. Machine Diagnostics Parameters
Diagnostics Submenu
(Displayed on Analyzer
1
st
Line)
Parameter (Displayed on
Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2
nd
Line)
Description
DRIVE:
DRIVE FOR/REV XXX% Displays drive joystick direction & demand
STEER RIGHT/LEFT XXX% Displays steer switch direction & demand
4WS NORMAL/COOR/CRAB Displays status of four wheel steer input (Displayed if 4WS = 1)
BRAKES LOCKED/RELEASED Displays brake control system status
CREEP ACTIVE/NOT ACTIVE Displays pump pot creep switch status
CRP MODE ACTIVE/NOT ACT Displays creep mode status
Q P R X 1 A C T I V E /N O T A C T I VE D i s p l ay s s t a t u s o f Q -P r o x s en s o r i n d r i v e j o y s t i c k ( D i s p la y e d i f JO Y S T I C K TY P E =
1)
Q P R X 2 A C T I V E /N O T A C T I VE D i s p l ay s s t a t u s o f Q -P r o x s en s o r i n d r i v e j o y s t i c k ( D i s p la y e d i f JO Y S T I C K TY P E =
1)
TWO SPEED OP/CL Displays status of two speed switch input if selected model has two speed.
2 speed mode ON/OFF Displays status of two speed valve if selected model has two speed
high engine OP/CL Displays status of high engine switch
LT F ANG XX.X Displays status of left front steer angle (Displayed if MODEL NUMBER = 7 or 8)
RT F ANG XX.X Displays status of right front steer angle (Displayed if MODEL NUMBER = 7 or
8)
LT R ANG XX.X Displays status of left rear steer angle (Displayed if MODEL NUMBER = 7 or 8)
RT R ANG XX.X Displays status of right rear steer angle (Displayed if MODEL NUMBER = 7 or 8)
DOS LIM sw OP/CL Displays status of Drive Orientation System limit switch. (Displayed if MODEL
NUMBER = 7 or 8)
DOS O/R sw OP/CL Displays status of Drive Orientation Limit System override switch. (Displayed if
MODEL NUMBER = 7 or 8)