Parts Manual Owner's manual
2-134 1200SJP 1350SJP 3121208
SECTION 2 TURNTABLE
31 3960422 2 Gasket, AC Receptacle (60Hz Spec Only)
32 4060802 1 Guard, Switch
33 4240018 AR Strap, Tie (Not Shown)
34 4300157 2 Stud
35 4360336 1 Switch, Toggle
36 4460051 1 Connector, Strain Relief (60Hz Spec Only)
37 4460071 1 Connector, Strain Relief (60Hz Spec Only)
38 4460315 2 Terminal, Spade (Not Shown - Use 1 each with items 30 & 31)
(60Hz Spec Only)
39 4460346 1 Terminal, Receptacle (60Hz Spec Only)
40 4460958 1 Receptacle (60Hz Spec Only)
41 Not Used
42 4711400 AR Flatwasher 1/4in Thin
43 4711600 1 Flatwasher 3/8in Thin
44 4751500 7 Flatwasher 5/16in Regular
45 4791400 2 Starwasher 1/4in
46 to 47 Not Used
48 4891800 4 Flatwasher 1/2in Hardened
49 4922972 1 Harness, Generator Cable B
4460225 1 Plug, Male 6 Position (Plugs into Generator)
4460226 6 Socket, Female (Use with 4460225)
4460807 1 Seal, Plug (Use with 4460225)
4460808 1 Seal, Interface (Use with 4460225)
See Note 1 Connector, Female 6 Position (Plugs into Control Box) (Note:
Not Available For Purchase)
See Note 6 Pin, Male (Note: Not Available For Purchase)
50 to 51 Not Used
52 1001118599 1 Shield, Pulley (Prior to SN 0300172839)
53 1001119250 1 Generator, 7500W
Use 70003631 1 Brushholder Assembly (Not Shown) (was p/n 7024484)
70001966 1 Bearing, Ball Radial (Located in Belt Tensioner Endbell - Not
Shown)
7027799 1 Block, Connector 6 Position (Not Shown)
70002460 1 Nut, Brass (Attaches p/n 7027799 to Cover) (Not Shown)
7024485 1 Breaker, Circuit 30Amp (Not Shown)
70001696 1 Boot, Breaker (Not Shown)
70002297 AR Stud 1/4in-20NC x 12-7/8in (Not Shown)
7026188 1 Clamp, Cable (Not Shown)
7026597 1 Connector with Leads (Not Shown)
70001100 1 Rotor/Armature (Not Shown)
70001384 1 Bearing, Ball Radial (Not Shown)
70003451 1 Stator (Not Shown)
Use 70004170 1 Plate, End Panel (Not Shown) (was p/n 70001972)
70000863 1 Fan (Not Shown)
70001974 1 Decal - Terminal Connections (Not Shown)
53A Use 70004171 1 Key (was p/n 7024561)
53B Use 70004170 1 Endbell, Rear (Brush Block End) (was p/n 70001385)
Use 70004170 1 Shroud, Endbell (was p/n 70002290)
70003452 1 Shroud, Endbell Panel
53C 70003450 1 Endbell, Front (Tensioner End)
FIGURE 2-26. 7500W SKYPOWER GENERATOR INSTALLATION - CATERPILLAR MACHINES
ITEM # PART NUMBER QTY. DESCRIPTION REV.