Service Manual Instruction Manual

SECTION 3 - CHASSIS & TURNTABLE

3121171 – JLG Lift – 3-11

DETAIL A

DETAIL B

11,12,A,G

11,12,B,G

11,12,C,G

11,12,E,G

11,12,F,G

A - Assemble to Axle Box Mid Plate; Typical 8 Places

B - A ss em bl e t o To p P la te of Ax le Boxes; Typic al 4 Pla ce s; Torque; Select appropriate bolt to ensure 0.5 ±0.062

inches (12.7 ± 1.587 mm) thread engagement.

C - Assemble to Side Plates of Axle Weldments; Typical 16 Places.

D - A ss em bl e t o F ro nt and Rear Plat es of Ax le Box es ; Ty pi c al 8 P la ce s.

E - Assemble to Top Plate of Axle Weldment; Typical 4 Places; Torque; Select appropriate bolt to ensure 0.5

±0.062 inches (12.7 ± 1.587 mm) thread engagement.

F - Assemble to Bottom Plate of Axle Box Weldment; Typical 8 Places.

G - See Axle Stop Shimming Procedure on Sheet 1

1. Axle Oscillation Cylinder

2. Axle

3. Axle Powertrack

4. Extension Cylinder

5. Axle Pivot Pin

6. Axle Limit Switch

7. Axle Stop Pin

8. Rubber Pad

9. Hose Clamp

10. Stop Block

11. Wear Pad

12. Shim

Figure 3-10. Oscillating Axle - Sheet 2 of 2