Service Manual Instruction Manual

SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS
3121171 – JLG Lift – 7-9
HD30/HDP20 Series Assembly
8. Grasp contact about 25mm behind the contact crimp
barrel.
9. Hold connector with rear grommet facing you.
10. Push contact straight into connector grommet until a
positive stop is felt. A slight tug will confirm that it is
properly locked in place.
NOTE: For unused wire cavities, insert sealing plugs for full envi-
ronmental sealing
HD30/HDP20 Series Disassembly
11. With rear insert toward you, snap appropriate size
extractor tool over the wire of contact to be removed.
12. Slide tool along into the insert cavity until it engages
contact and resistance is felt.
13. Pull contact-wire assembly out of connector.
NOTE: Do Not twist or insert tool at an angle.
Figure 7-14. HD/HDP Contact Installation
A
B
C
Figure 7-15. HD/HDP Locking Contacts Into Position
Figure 7-16. HD/HDP Contact Removal
AB
C
Figure 7-17. HD/HDP Unlocking Contacts