Service Manual Instruction Manual

SECTION 6 - JLG CONTROL SYSTEM
3121171 – JLG Lift – 6-101
SOFT O/R (C L o r O P) D is pl ay s t he OP EN o r CLO SE D c on di tio n of th e sof t to uch ove r r id e s witc h
GENSET/WELDER (CL or OP) Displays the OPEN or CLOSED condition of the GENSET/WELDER switch
LIGHTS (CL or OP) Displays the OPEN or CLOSED condition of the LIGHTS switch
BSK TILT1 (X.X) Displays the status of basket tilt sensor #1
BSK TILT2 (X.X) Displays the status of basket tilt sensor #2
AXLE RET SW (CL or OP) Displays the OPEN or CLOSED condition of the axle retract switches
AXLE EXT SW (CL or OP) Displays the OPEN or CLOSED condition of the axle extend switches
AXLE LIM SW (RET or EXT) Displays the condition of the AXLE LIMIT SWITCH case
DOS LIM SW (CL or OP) Displays the OPEN or CLOSED condition of the drive orientation switch
CAPACITY SW (500 or 1000) Displays the status of the capacity switch
OSC AXLE P SW (CL or OP) Displays the condition of the axle pressure switch
SKY WELDER (YES or NO) Indicates if the accessory has been included in the boom sensor calibration
SKY C UT T ER ( YE S o r N O) Indic at es if th e acc es so r y h as b een incl uded in the b oo m sen sor calibra ti on
SKY GLAZIER (YES or NO) Indicates if the accessory has been included in the boom sensor calibration
SKY BRIGHT (YES or NO) Indicates if the accessory has been included in the boom sensor calibration
PIPE RACKS (YES or NO) Indicates if the accessory has been included in the boom sensor calibration
C AM ER A M OU NT ( Y ES or NO) Indic at es if t he a cc es so r y ha s bee n incl ude d in th e boo m s ensor calib ra ti on
H OIL TEMP SW (CL or OP) Displays the status of the hot oil temperature switch
ML PILOT P SW (CL or OP) Displays the status of th e m ai n lift pil ot pre ss ur e s wi tc h
TRANSPORT DATA:
TRANSPORT (YES or NO) Displays the status of the TRANSPORT case
L EN GT H ZONE ( A o r B or C or d or E RR) Di sp la ys the sta tu s of the main boom l engt h zo ne
ANGLE ZONE (1 or 2 or 3 or 4 or 5 or 6 or 7 or 8 or HI) Displays the status of the main boom angle zone
ABOVE ELEV. (YES or NO) Displays the current condition of the ABOVE ELEVATION case
TWR BOOM (OUT or IN) TRN Displays the tower status being within or outside of the transport case
TWR BOOM (EXT or RET) Displays the tower status
TWR BOOM (ABV or BLW) ELE Displays the tower status being above or below of the elevated case
MAIN BOOM (EXT or RET) Displays the main boom status
Table 6-7. Analyzer Diagnostics Menu
Menu: Submenu: Selection:
Description: