Service Manual Instruction Manual

SECTION 4 - BOOM & PLATFORM
3121171 – JLG Lift – 4-85
5. Install the shoulder screws, retaining rings, and pin
securing the end of the telescope cylinder. It may be
necessary to use the analyzer Service Mode to align the
pin.
6. Carefully raise the upper link into position. Install the
bolt, keeper, and pin securing the upper link to the base
boom.
7. Install the rear boom cover and secure it in place with
the retaining bolts.
8. Remove all blocking used during the Removal proce-
dure.
9. If necessary, refer to Removal, and use the analyzer Ser-
vice Mode procedure to retract the boom.