Service Manual Instruction Manual

SECTION 4 - BOOM & PLATFORM
4-70 – JLG Lift – 3121171
13. Press the ENTER key. The control system will perform the
following checks:
The axles must be extended or the DOS (Direction of
Steering) switch must indicate the turntable is between
the rear tires, otherwise the analyzer will read:
14. If the main boom angle sensors are calibrated and work-
ing properly the control system will verify the main
boom angle readings are between +0.0 and +15.0 (ref
tower boom). If they are calibrated and working prop-
erly and outside the angle limits, the analyzer will read:
15. After the successful completion of the checks, the ana-
lyzer will read:
16. Enter code 74466. The analyzer will read:
WHEN THE STABILITY CONTROL IS OFF THE MACHINE WILL TIP IF USED
INCORRECTLY.