Service Manual Instruction Manual

SECTION 4 - BOOM & PLATFORM
3121171 – JLG Lift – 4-65
16. Enter code 95268. The analyzer will read:
WHEN THE STABILITY CONTROL IS OFF THE MACHINE WILL TIP IF USED
INCORRECTLY.
17. Press the ENTER key to acknowledge the stability control
is turned off. The analyzer should read:
18. The control system will now allow only tower telescope
using the tower lift switch on the ground console.
BEFORE CONTINUING WITH THIS PROCEDURE, DOUBLE CHECK ALL SUPPORT-
ING DEVICES AND MID BOOM RESTRAINING CHAIN.
19. Extend the tower fly section no more than necessary to
gain access to the telescope cylinder retaining pin
(about 5.5 ft. [1.7 m]). When access is gained to the tele-
scope cylinder retaining pin, remove the four shoulder
bolts and two snap rings that hold it in place and
remove the telescope cylinder retaining pin.
20. At the rear of the tower boom, tag and disconnect the
wires going to the angle sensors. Remove the bolts and
washers that fasten the angle sensors to the boom sec-
tion and remove the angle sensors.