Service Manual Instruction Manual

SECTION 1 - SPECIFICATIONS
1-6 – JLG Lift – 3121171
1.11 LUBRICATION & OPERATOR MAINTENANCE
NOTE: The following numbers correspond to those in Figure 1-1.,
Lubrication & Operator Maintenance Diagram.
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION UNDER NOR-
MAL CONDITIONS. FOR MACHINES USED IN MULTI-SHIFT OPERATIONS AND/
OR EXPOSED TO HOSTILE ENVIRONMENTS OR CONDITIONS, LUBRICATION
FREQUENCIES MUST BE INCREASED ACCORDINGLY.
NOTE: It is recommended as a good practice to replace all filters
at the same time.
1. Swing Bearing - Remote Lube
Lube Point(s) - 2 Grease Fitting
Capacity - A/R
Lube - MPG
Interval - Every 3 months or 150 hours of operation
Figure 1-1. Lubrication & Operator Maintenance Diagram
Table 1-19. Lubrication Specifications
KEY SPECIFICATIONS
MPG Multipurpose Grease having a minimum dripping point of 350° F (177°
C). Excellent water resistance and adhesive qualities, and being of
extreme pressure type.
(Timken OK 40 pounds minimum.)
EPGL Extreme Pressure Gear Lube (oil) meeting API service classification GL-5
or MIL- Spec MIL-L-2105
HO Hydraulic Oil. API service classification GL-3, e.g. Mobilfluid 424.
EO Engine (crankcase) Oil. Gas - API SF, SH, SG class, MIL-L-2104. Diesel - API
CC/CD class, MIL-L-2104B/MIL-L-2104C.