Service Manual Instruction Manual

SECTION 3 - CHASSIS & TURNTABLE
3121171 – JLG Lift – 3-119
8. Pull the pump assembly away from the engine.
9. Using a ratchet strap, support the pump in a position
that will keep the pump from interfering with engine
removal.
10. Disconnect all fuel lines from the engine. Cap all open
hoses to prevent fuel leakage.
11. Swing the engine out to gain access to the back of the
engine, and tag and disconnect all electrical wiring from
relays, switches, etc. Carefully pull the disconnected har-
nesses and fuel lines away from the engine.
12. Using an adequate lifting device, support the weight of
the engine assembly. Remove the pivot pin.
NOTE: The engine assembly weighs approximately 1275 lbs. (579
kg).
13. Carefully lift the engine assembly away from the
machine.
14. If installing a new engine, transfer any necessary compo-
nents from the old engine assembly onto the new
Engine Assembly.