Service Manual Instruction Manual

SECTION 3 - CHASSIS & TURNTABLE
3121171 – JLG Lift – 3-113
Changing Engine Oil
1. Allow the engine to warm up. The engine oil should
reach approximately 176° F (80° C).
2. Make sure the machine and engine are level.
3. Switch off the engine.
4. Place an oil tray under the engine.
5. Open the oil drain valve.
WHEN DRAINING HOT ENGINE OIL THERE IS A RISK OF SCALDING.
DO NOT LET USED OIL RUN INTO THE SOIL; COLLECT THE USED OIL IN A CON-
TAINER SUITABLE FOR DISPOSAL OR RECYCLING. DISPOSE OF THE USED
ENGINE OIL IN ACCORDANCE WITH ENVIRONMENTAL REGULATIONS.
6. Drain the oil.
7. Close the oil drain valve.
8. Pour in new engine oil. Refer to Section 1 for capacity
and refer to Figure 3-62., Engine Oil Viscosity for the
proper grade.
Changing the Oil Filter
1. Wipe the area around the filter to clean any dirt from the
area.
Figure 3-62. Engine Oil Viscosity