Service Manual Instruction Manual

SECTION 3 - CHASSIS & TURNTABLE
3121171 – JLG Lift – 3-89
2. The Torqlink™ inner housing bearing/bushing (13) can
now be pressed into its counterbore in housing (18)
flush to 0.03 inch (.76 mm) below the housing wear
plate contact face. Use the opposite end of the bearing
mandrel that was used to press in the outer bearing/
bushing (19).
3. Press a new dirt and water seal (20) into the housing (18)
outer bearing counterbore.
The Torqlink™ dirt and water seal (20) must be pressed in until
its’ flange is flush against the housing.