Service Manual Instruction Manual

SECTION 3 - CHASSIS & TURNTABLE
3-82 – JLG Lift – 3121171
5. If the end cover (2) is equipped with shuttle valve com-
ponents, remove the two previously loosened plugs
(21).
BE READY TO CATCH THE SHUTTLE VALVE OR RELIEF VALVE COMPONENTS
THAT WILL FALL OUT OF THE END COVER VALVE CAVITY WHEN THE PLUGS ARE
REMOVED.
NOTE: The insert and if included the orifice plug in the end cover
(2) must not be removed as they are serviced as an integral
part of the end cover.
1. Speci al Bolts
2. En d Cove r
3. S ea l R ing -Co mm ut at or
4. S ea l R ing
5. Co mm ut at or Rin g
6. Co mm ut at or Rin g
7. Man ifo ld
8. Roto r S et
8A.Rotor
8B. Stator or Stator Vane
8C. Vane
8D. Stator Half
9. We ar Pl at e
10. Drive Link
12. Coupling Shaft
13. Bearing/Bushing, Inner
14. Thrust Washer
15. Thrust Bearing
16. S ea l
17. Back- up Wa sh er
18. Hou sing
18A. O-Ring
19. B ea ri ng /B ushi ng, Ou te r
20. D ir t & Wate r S e al
21. Plug
Figure 3-49. Swing Drive Motor