Service Manual

SECTION 4 - CONTROL COMPONENTS

3121228 – JLG Lift – 4-15

4.5 PLATFORM CONTROL CONSOLE -

SERVICE PROCEDURES

General

DO NOT ATTEMPT TO DISASSEMBLE THE PLATFORM CONTROL

BOX IF MACHINE IS STILL UNDER WARRANTY. OPENING THE

PLATFORM CONTROL BOX WHILE THE MACHINE IS UNDER

WARRANTY WILL VOID THE WARRANTY. IF UNDER WARRANTY

REQUEST A REPLACEMENT BOX FROM THE FACTORY.

The platform control console allows for replacement of

nine (9) components.

• Emergency Stop Switch

• Key Switch

• Joystick Assembly

• Display/Controller Module

• Drive/Lift Mode Selector Switch

• Horn Button Switch

•Rear Cover

• Wiring Harness Connector Socket

• Mounting Bracket

Remove Platform Control Console

First remove the platform control console completely from

the platform assembly, See Section 4.2, Control Compo-

nents - Installation, Platform Control Console Installation.

Figure 4-4. Platform Control Console Components.

1. E-Stop/Shut Down Switch 6. Horn Button Switch

2. ON/OFF Key Switch 7. Rear Cover

3. Joystick Assembly 8. Wiring Harness Connector

4. Display/Controller Module 9. Adjustable Mounting Bracket

5. Drive/Lift Mode Selector Switch