Service Manual

SECTION 4 - CONTROL COMPONENTS
3121228 – JLG Lift – 4-13
Table 4-1. Ground Control Module - Field Programmable Settings and Factory Preset. (10MSP)
Level-2: Ser vi ce Le vel Set ti ngs On LCD Di sp lay : YES = HIG H =
↑
Level-3: Ope rat or Le vel Set ti ngs NO = L OW = ↓
LEVEL PROGRAMMABLE ITEM
FACTORY
PRESET
SETTING RANGE
2 Back to Main – Return to Programming Menu
3 Set Language
NOTE: There are two production modules available at this time,
one for North/South American and European Lan-
guages, and one for Asian Languages.
1 1 - English 6 - Italian
2 - German 7 - Swedish
3 - Dutch 8 - Brazilian Portuguese
4 - French 9 - Finnish
5 - Spanish
2 1 - English 3 - Japanese
2 - Chinese
2 Set Maximum Lift Up Speed 100% 0 - 100%
2 Set Maximum Lift Down Speed 100% 0 - 100%
2 Zero the On-Board Tilt Sensor NO YES/NO
2, 3 Set Sleep Time 10 MINS 0 - 60 MINS
2 Set Polarity Of Left Pot Hole Input 1 0 0=DISABLED / 1=LOW / 2=HIGH
2 Set Polarity Of Right Pot Hole Input 2 0 0=DISABLED / 1=LOW / 2=HIGH
2 Set Polarity Of Up Limit/Elevation Input HIGH HIGH/LOW
2 Set Polarity Of Charger Inhibit LOW HIGH/LOW
2, 3 Set Polarity Of The Keypad Code LOW HIGH/LOW
2 Set Polarity Of Ancillary Input 1 HIGH HIGH/LOW
2 Set Polarity Of Ancillary Input 2 LOW HIGH/LOW
2, 3 Enable Detection Of Horn Open Circuit NO YES/NO
2, 3 Enable Detection Of Beacon Open Circuit NO YES/NO
2 Enable Obstruction Sensor System (OSS) NO YES/NO
2 Enable Detection Of Ancl. #1 Open Circuit NO YES/NO
2 Enable Detection Of Ancl #2 Open Circuit NO YES/NO
3 Forward Alarm Disable NO YES/NO
2 Brush Wear Sensor Timer Reset — BLANK/WORN
3 OSS Diagnostic NO YES/NO
2 Load Sensing (LSS) OFF OFF/CUTOUT PLAT./CUTOUT ALL
2 Aux. 1 - Inhibit - (Active when Ancilliary 1 is set to HIGH) 4 0=Inhibit Lift
1=Inhibit Drive when Platform is elevated
2=Inhibit Drive regardless of Plat. position
3=Inhibit Lift and Drive when Plat. elevated
4=I nhi bi t L if t a nd Dri ve re ga rdl es s of Pl at .
position
2 Aux. 2 - Inhibit - (Active when Ancilliary 2 is set to HIGH) 0 0=Inhibit Lift
1=Inhibit Drive when Platform is elevated
2=Inhibit Drive regardless of Plat. position
3=Inhibit Lift and Drive when Plat. elevated
4=I nhi bi t L if t a nd Dri ve re ga rdl es s of Pl at .
position
2 Aux . 1 - Tie Down 1 0=Disabled
1=trip if low at start-up
2=trip high at start-up
2 Aux. 2 - Tie Down 0 0=Disabled
1=trip if low at start-up
2=trip high at start-up