User's Manual

For Technical Support Call 813.689.9932 option 2 For Technical Support Call 813.689.9932 option 2
Pairing and Operation
Pairing Foot Switches:
1. Press and hold the PROGRAM button on the top of the
unit for 3 seconds until the LED turns green in color
(HPU will also beep).The unit is now ready to be paired
with the foot switches.
2. Press the UP foot switch button for 1 second and release
(See Figure 1) The green LED on the unit(s) will initially
turn off, then flash green steadily (HPU will also beep)
indicating that the pairing is complete.
NOTE: If dual units are installed, repeat Steps 1-3 to pair
multiple units to a single foot switch. Up to ten (10)
wireless controllers can be programmed to each unit.
3. For the DOWN foot switch button, repeat Step 1 to
enter programming mode. Next, press the DOWN foot
switch button for 1 second and release. (See Figure 2)
The green LED on the unit(s) will initially turn off, then
flash green steadily (HPU will also beep) indicating that
the pairing is complete.
4. The foot switches are now paired to the unit. Test their
functionality by following the operating instructions
to ensure that the pairing procedure was completed
successfully.
Operating Instructions:
1. To raise or lower the Power-Pole anchor, press and hold either the UP or the DOWN foot switch
button. The anchor will only continue to move so long as you keep the button depressed.
Auto Mode: Double tapping (depressing and releasing 2 times within 1 second) either the UP
or the DOWN foot switch button will cause the anchor to retract or deploy automatically. The
anchor will continue to move in said direction until it either retracts completely (up) or senses a
solid bottom surface (down).
NOTE: The wireless foot switch comes set to 100% speed setting. This can be adjusted by
downloading the C-Monster App and connecting to the system via Bluetooth with your Android
powered smart phone. For more information refer to your Owner’s Guide.
PROGRAM
LED
Hydraulic Pump Unit (HPU)
MICRO Driver Unit
LED
PROGRAM
Figure 1 Figure 2
Changing the Battery and Installation
Changing the Battery:
1. Remove the (3) screws with a #2 Phillips-head
screwdriver.
2. Take the foot switch to a dry location and separate the
foot switch cover from its base using a small flat head
screwdriver (See Figure 1)
3. Remove the rubber switch membrane and the circuit
board from the foot switch base (See Figure 2)
4. Remove the battery from the holder on the back of the
circuit board and replace with any CR2032 3V Lithium
Coin Battery.
5. Inspect the inside of the foot switch case for signs of
moisture or damage to the rubber seal. If the rubber
seal appears damaged, or if moisture is found, please
contact our technical support staff at
813-689-9932 option 2.
6. Place the circuit board back into its base with circuit
board level and small black caps placed over each
circuit board button (See Figure 3)
NOTE: Each small black cap when pressed should push
down and come up when released. If the black cap
does not push down, remove black cap, rotate 1
quarter turn and re-install.
7. Install rubber switch membrane back into the foot
switch base and ensure that the rubber switch
membrane is seated properly prior to installing the
cover (See Figure 4)
SWITCH COVER
CIRCUIT BOARD
SWITCH COVER
CIRCUIT BOARD
BLACK CAPS
Figure 2
Figure 3
Figure 4
Figure 1
C
C
C
Installation Instructions:
1. Locate a suitable area with a flat surface to mount
the UP and DOWN foot switches.
2. Mark and drill a hole with 1/8” drill bit to fasten
foot switches using the (6) screws C supplied
(do not over tighten).