User's Manual

DRAFT
B. Alternately, the remote control can be used to enable the auto mode. Double tapping (depressing
and releasing 2 times within 1 second) either the “up” or the “down” button on the remote control will
cause the anchor to retract or deploy automatically. The Power-Pole shallow water anchor will
continue to move in said direction until it either retracts completely or senses a solid bottom surface.
Smart Phone Application
The Power-Pole shallow water anchor smart phone application will allow you to do the following:
- adjust the HPU’s slow, medium, and fast settings
- enable and disable the auto mode
The application is available for free in the Android Marketplace.
Precautions
- Prior to use, read this instruction manual carefully. Become familiar with the controls and how
to operate your Power-Pole shallow water anchor properly.
- Do not allow children to operate or tamper with the Power-Pole shallow water anchor without
adult supervision.
- Do not modify the unit in any way.
- Use only genuine Power-Pole shallow water anchor accessories.
- Always disconnect the 12 volt power source from the Power-Pole shallow water anchor before
servicing.
- In the event of HPU failure, the Power-Pole shallow water anchor may be manually stowed by
activating the pole protector valve.
o Do so by applying enough upward force to lift the unit into its upright position.
o If the Power-Pole shallow water anchor is not within reach, you may drive the boat
toward shallow water. Doing so will apply enough upward force to lift the unit within
reach.
- Be sure to have the Power-Pole shallow water anchor in the stowed (fully upright) position
while operating your vessel at high speeds.
- Always maintain a safe distance between the Power-Pole shallow water anchor and your
extremities. Avoid wearing loose clothing within close proximity of the unit. Failure to do so
may result in bodily injury.
- Do not use the Power-Pole shallow water anchor as a form of assistance for entering or exiting
the vessel.
- Never leave your boat unattended with the Power-Pole shallow water anchor as the primary
anchorage.
- During situations with high wind or rough seas, the Power-Pole shallow water anchor may
release holding pressure in order to protect your vessel’s transom.
- If any debris gets caught around the Power-Pole shallow water anchor, disconnect the 12 volt
power source prior to removal.
- The devices listed in this installation manual comply with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) The devices may not cause harmful interference,
and (2) This device must accept any interference received, including interference that may
cause undesired operation.