User's Manual

DRAFT
installing two Power-Pole shallow water anchors. The “dual units” instructions must also be used when
installing a second unit.
-Note: Assigning a single unit as either a port side or starboard side unit will cause adverse
operating behavior.
Single unit
A. Locate the “program” button on the top of the HPU, and depress and hold it for 6 seconds until the
LED steadily illuminates red in color. The LED will initially illuminate green (after 3 seconds), but will
change to red after 6 seconds, thus indicating that the unit is ready to be programmed. (See Image
#9) FPO_Image_#9
B. Next, depress and hold both the “up” and the “down” buttons on the HPU simultaneously. The LED
will flash red 3 times indicating that that the programming has been completed successfully.
Dual units
A. Using the “up” and “down” buttons on both HPUs, determine which HPU controls the port side
Power-Pole shallow water anchor and which one controls the starboard side. (See Image #9)
B. With both HPUs identified, begin with the starboard side unit. Locate the “program” button on the
top of the HPU, and depress and hold it for 6 seconds until the LED steadily illuminates red in color.
The LED will initially illuminate green (after 3 seconds), but will change to red after 6 seconds, thus
indicating that the unit is ready to be programmed.
C. Next, depress and hold the “down” button on the starboard side HPU. The LED will flash red 1
time indicating that that the programming has been completed successfully, and the HPU has been
assigned as the starboard side unit.
D. Repeat the programming procedure with the port side HPU, but instead depress and hold the “up”
button on the HPU. This time the LED will flash red 2 times indicating that that the programming has
been completed successfully, and the HPU has been assigned as the port side unit.
Step 8: Programming the Dash Switch and Remote Control
A. Locate the “program” button on the top of the HPU, and depress and hold it for 3 seconds until the
LED steadily illuminates green in color. The unit is now ready to be programmed with a dash switch or
remote control.
-Note: When installing dual units, this procedure need only be performed on one HPU.
B. Next, depress and release either the “up” or the “down” button on the dash switch 1 time. The
green LED will initially turn off, and then it will flash steadily indicating that the programming has been
completed. (See Image #10) FPO_Image_#10
C. The dash switch is now programmed. Test its functionality with both the “up” and the “down”
buttons to ensure that the programming procedure was completed successfully.
D. Repeat the programming procedure with the remote control. (See Image #11) FPO_Image_#11