User Manual

JKSOGS155JKS Adjustable Trackbar Installation

Page 1

INSTALLATION

INSTRUCTIONS

Product: Adjustable Trackbar

Part Number: JKSOGS155

Welcome

CONGRATULATIONS on purchasing a new Adjustable

Trackbar from JKS Manufacturing. We are committed to

providing you with the best products available and your

satisfaction is our rst priority.

PLEASE READ these Installation Instructions carefully,

and save them for future reference, as they contain impor-

tant installation and maintenance information.

Important

NOT COMPATIBLE WITH right hand drive vehicles.

CHECK TORQUE SPECIFICATIONS regularly.

Tools Required

 Metric/Standard Socket Wrench Set

 Torque Wrench

 Tape Measure

 1-1/2” Open-End Wrench

 Heavy Duty Ratchet Strap *

 Anti-Seize Lubricant

 Hydraulic Press *

 Wheel Bearing Grease

* Asterisk denotes tools that are not required for some applica-

tions. Thoroughly read instructions rst to determine which tools

will be required for your application.

Parts

Description

Male Threaded (Axle) End

Female Threaded (Chassis) End

1” NF Jam Nut

Sleeve

Polyurethane Bushing

Sleeve

Polyurethane Bushing

517-278-1226 • tech@jksmfg.com • www.jksmfg.com

491 W. Gareld Avenue, Coldwater, MI 49036

PAGE 1
Product: Adjustable Trackbar Part Number: JKSOGS155 INSTALLATION INSTRUCTIONS 517-278-1226 • tech@jksmfg.com • www.jksmfg.com 491 W. Garfield Avenue, Coldwater, MI 49036 Welcome Parts CONGRATULATIONS on purchasing a new Adjustable Trackbar from JKS Manufacturing. We are committed to providing you with the best products available and your satisfaction is our first priority.
PAGE 2
Installation 1. REMOVE ORIGINAL EQUIPMENT (OE) REAR TRACK BAR Remove rear track bar and mounting hardware per factory service manual instructions for your vehicle. Retain original mounting hardware as it is required for Adjustable Trackbar installation. HINT: The original trackbar bushings may be retained as spares for your Adjustable Trackbar if replacement parts are ever needed. See Maintenance section for details. 2. If the two measurements are equal, the axle is centered.
PAGE 3
Maintenance Check torque specifications regularly. Regular cleaning with pressurized water is recommended to maximize reliability. The original equipment trackbar uses the same bushing size as the JKS Adjustable Trackbar. Upon removal of the original trackbar, the OE bushings should be retained if in good condition. In the unlikely event that the Adjustable Trackbar bushings wear out, the OE trackbar bushings may be used as replacements.