Manual

ManualsBrandsJKS ManualsCarOGS151

JKSOGS151JKS Adjustable Track Bar Installation

Page 1

INSTALLATION

INSTRUCTIONS

Product: Adjustable Track Bar

Part Number: JKSOGS151

Applications: Wrangler TJ, 1997-06 (rear only)

Welcome

CONGRATULATIONS on purchasing a new Adjustable

Trackbar from JKS Manufacturing. We are committed to

providing you with the best products available and your

satisfaction is our rst priority.

PLEASE READ these Installation Instructions carefully,

and save them for future reference, as they contain impor-

tant installation and maintenance information.

Tools Required

 Hydraulic Floor Jack & Jack Stands

 Metric/Standard Socket Wrench Set

 Torque Wrench

 1-1/2” Open-End Wrench

 T55 Torx Driver (for OE track bar bolt)

 Tape Measure

 Heavy Duty Ratchet Strap *

 Anti-Seize Lubricant

 Grease Gun with Zerk Fitting Coupler

 Wheel Bearing Grease

* Asterisk denotes tools that are not required for some applica-

tions. Thoroughly read instructions rst to determine which tools

will be required for your application.

Parts

Description Part No. QTY

Female Threaded (Chassis) End 03053

1” NF Jam Nut 36270

Male Threaded (Axle) End 03054

Sleeve 138

Polyurethane Bushing Half M03618-BK-01

Snap Ring CE91125

Spherical Bushing CEES9385

Spherical Ball CE911225

Retaining Washer CE91126GM

Grease Zerk 7201

Important

VEHICLE MUST BE EQUIPPED with a CV type

driveshaft if installing this product with angled reloca-

tion bracket on axle housing.

NOT COMPATIBLE WITH right hand drive vehicles.

CHECK TORQUE SPECIFICATIONS regularly.

517-278-1226 • tech@jksmfg.com • www.jksmfg.com

491 W. Gareld Avenue, Coldwater, MI 49036

Summary of content (3 pages)

PAGE 1
Product: Adjustable Track Bar Part Number: JKSOGS151 INSTALLATION INSTRUCTIONS Applications: Wrangler TJ, 1997-06 (rear only) 517-278-1226 • tech@jksmfg.com • www.jksmfg.com 491 W. Garfield Avenue, Coldwater, MI 49036 Welcome CONGRATULATIONS on purchasing a new Adjustable Trackbar from JKS Manufacturing. We are committed to providing you with the best products available and your satisfaction is our first priority.
PAGE 2
Installation 1. 3. REMOVE REAR TRACK BAR Locate bag of parts containing Polyurethane Bushing Halves (E) and Sleeve (D). Raise and support vehicle chassis with jack stands positioned in front of the rear lower suspension arm brackets. Remove rear wheels from vehicle. Liberally apply wheel bearing grease to surface of bushings. Assemble Polyurethane Bushing Halves (E) and Sleeve (D) at Chassis End (A) of track bar as indicated in the parts diagram on page 1.
PAGE 3
If the two measurements are equal, the axle is centered. If the measurements vary, divide the difference in half to determine the amount of adjustment required. HINT: If the axle housing is not centered, the chassis can be laterally shifted using either of the following methods. 7. Take measurements again to ensure axle housing is perfectly centered and make any final adjustments if necessary.