QuickTap IFB Telephone Handset IFBTap User Guide JK Audio
Connection Install QuickTap IFB between the handset and the telephone base of your existing telephone. 1. Unplug the handset cord from your telephone base. 2. Using the black handset jumper cord that we have provided, connect the Phone jack of QuickTap IFB to the handset jack on your telephone base. 3. Plug your handset cord, and handset, into the Handset jack on QuickTap IFB. 4. Connect your audio equipment to the line output jack on QuickTap IFB.
Operation The audio output jacks provide a mix of both sides of the conversation. In other words, as you talk down the handset your speech will come back on this jack mixed with the audio from the other side of the call. You do not need to connect the handset to QuickTap IFB if you only want clean audio from the phone line.
FAQ’s ? What kind of earpiece should I use with the ! QuickTap IFB? Any standard earpiece should work fine as long as it has an impedance greater than 600 ohms. ? I want to send the QuickTap IFB's XLR out! put to an auxiliary input of my mixer but I'm not getting any audio. What's wrong? The QuickTap IFB is a passive device that outputs a mic level signal. You'll need to send the output to a mic input on your mixer.
Specifications Mini Output : Connector Output Impedance Output Level Isolation 1/8" Mono jack 600 ohms 100 mV RMS 1500 VRMS XLR Output: Connector Output Impedance Level Isolation Male SLR Jack 600 ohms 100 mV RMS 1500 VRMS Handset and Telephone connectors: Modular 4pin/4wire handset jacks Compatibility Note: Not all telephones are built alike so we cannot guarantee QuickTap IFB will work with every handset design out there. We designed QuickTap IFB to work with most popular telephones.
FCC Registration Your new JK Audio product has been registered with the Federal Communications Commission (FCC). This product complies with the standards in Part 68 of the FCC rules. The FCC requires us to provide the following information: 1. Connection and use with the nationwide telephone network The FCC requires that you connect this telephone equipment to the national telephone network through a FCC registered telephone. This equipment may not be used with Party Line Service or Coin Telephone Lines. 2.
FCC Registration (continued) Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents or by others who may be authorized by the FCC. For repair procedures, follow the instructions outlined under the warranty section of the manual. 4. Rights of the telephone company If telephone equipment is causing harm to the network, the telephone company may temporarily discontinue your telephone service. If possible, they will notify you before they interrupt service.
Warranty The model QuickTap IFB is covered by a 2 year warranty to be free from defective workmanship and materials. In the event that the QuickTap IFB needs repair, you must call us to get an authorization, and then carefully pack and ship it to us. You will pay for shipping to us and we will pay for return back to you, UPS ground. No free repairs will be made if the defect was caused by misuse, weather conditions, or other cause, except for defective workmanship or materials.
