User Manual

3
Introduction
To achieve maximum battery capacity, BlueSet should
be fully charged before its first use. While this battery
will normally charge in about 2 1/2 hours, please allow
4-5 hours for this first charge. Connect the power
supply cable to the mini USB connector on the BlueSet
to charge the battery. The red LED will illuminate to
indicate when the battery is charging. Please see page
9 for more information. This device can be used with
the power cable connected if desired.
BlueSet connects directly to the headset jack on your
Party-Line belt pack unit, replacing the dynamic or
electret headset. Before you turn the BlueSet on, be
sure to set the Headset/Phone switch to the correct
position. If you change that switch while the unit is on,
you will need to power the unit off, then power the unit
on before the change takes effect.
Mode Switch
In the Bluetooth world, a device is either a Master (like
a cell phone, sound card or music player) or a Slave
(like a headset or car hands-free kit).
Select Headset if you will be using BlueSet with a
Bluetooth enabled headset or any device that emulates
a headset.
Select Phone if you will be using BlueSet with a cell
phone or other master device.