Instructions

Manual-125SATA V2.4B
---Front panel--- (see picture B)
---Back View --- (Picture C)
Picture C
No.1--- (POWER SW): Power ON/OFF.
No.2--- Power LED: Power on, LED indicates Green.
No.3--- HDD Access LED : Yellow blinking for Accessing(No indication, if not accessing)
No.4--- (POWER1): 15pin Power connector
No.5--- 4pin Power connector
No.6--- 7pin Serial ATA Signal connector
No.7--- HD LED SWITCH (Enable/Disable)
1) DIP Switch set to ENABLE – The front HDD accessing LED can work normal
(Yellow color for accessing and no indication if there is no accessing)
2) DIP Switch to DISABLE—No LED indication for the front HDD accessing (*this
function is designed for some special HDDs which are not recognized under
normal HDD indication status but when it is set to DISABLE, the HDD can work;
however, the LED indication function is invalid. This is the special design to make
those special HDDs can work but without LED indication).
Picture B