335w Silver Poly Manual

- 3 -

Artificially concentrated sunlight shall not be directed on the module or panel.
 Front protective glass is utilized on the module. Broken solar module glass is an electrical
safety hazard (may cause electric shock or fire). These modules cannot be repaired and
should be replaced immediately.
 To reduce the risk of electrical shocks or burns, modules may be covered with an opaque
material during installation to avoid injury.
 The fire rating of this module is valid only when mounted in the manner specified in the
mechanical mounting instructions.
 The module is considered to be in compliance with UL 1703 only when the module is
mounted in the manner specified by the mounting instructions below.The fixation with
bolts and/or the fixation with clamps at long side of frames of Jinko modules have been
UL approved. The fixation with clamps at short side of frames and/or at the long & short
sides of frames of Jinko modules have not been UL approved.
 All installations must be performed in compliance with the National Electrical Code (NEC)
and modules installed in Canada need to follow Canadian Electric Code.
 A module with exposed conductive parts is considered to be in compliance with UL 1703
only when it is electrically grounded in accordance with the instructions presented below
and the requirements of the National Electrical Code.
 Any module without a frame (laminate) shall not be considered to comply with the
requirements of UL 1703 unless the module is mounted with hardware that has been
tested and evaluated with the module under this standard or by a field Inspection
certifying that the installed module complies with the requirements of UL 1703.
 The installation work of the PV array can only be done under the protection of
sun-sheltering covers or sunshades and only qualified person can install or perform
maintenance work on this module.

Follow the battery manufacture‟s recommendations, if batteries are used with modules.
 Do not use this module to replace or partly replace roofs and walls of living buildings.
 Do not install modules where flammable gas may be present.
 Do not touch live terminals with bare hands. Use insulated tools for electrical
connections.
 Electric Shock and Burn Hazard
 This photovoltaic module produces
electricity when exposed to the sun
Warning