Operation Instructions

3）As shown in Figure 3 above, hold the damper with the left hand and lift it slowly.
Adjust the position of the screw hole of the cylindrical movable pin with the right
hand, and then align the mouth of the adjusting screw with the screw hole of the
cylindrical movable pin. Slightly lift the left hand to make the mouth of the adjusting
screw completely align with the screw hole. Then screw the adjusting screw with the
right hand clockwise, and the screw thread goes more than 5mm out of the
cylindrical movable pin.
Note: In this process, the left hand shall always lift the damper upward with a little
force to prevent the damper from falling and hurting the hand!
4）As shown in Figure 4 above, the next step is to slide the cylindrical movable pin to
drive the whole damper slide from the slot C on the iron stand to the slot D, so that
it can be adjusted during riding training.