Operation Instructions

Note: during operation, hold the damper with one hand gently, and hold the
cylindrical movable pin with the other hand to slide it from slot C to slot D. Pay
attention to prevent hand injury during sliding!
Step 3. Bike Installation and Debugging
1）Place the bike trainer on stable ground, and adjust the rotary knobs on both sides
of the bike trainer so that the distance between the axle sleeve A and the axle sleeve
B is greater than the length of the bike quick release, as shown in Figure 5.
2）Replace the original quick release of the rear wheel of the bike into the standard
quick release, as shown in Figure 5. Lift the bike with a single hand to a certain
height. First, embed the B end of the quick release into the B hole of the axle sleeve.
Straighten the bike and adjust the knobs on the sides of the bike, insert the A end of
the quick release into the A‐hole of the axle sleeve and tighten the knob.