User Manual

)4))GX\OTM
--------------------------------------------------------------------------------------------------------------------------------------------
3.Install Material (PMMA )




/TYKXZZNKUXOMOTGR9*IGXJGTJKTY[XKZNGZZNK]UXQVOKIKNGYHKKT
LO^KJ
+TZKXZNKSKT[$3U\KG^OY$3U\KSS$3U\K>?@RKZZNKZOV
ULZNK)4)ZUUROYVUOTZZUZNKIKTZKXULZNKY[XLGIKULZNK]UXQVOKIKXKLKX
ZUZNKZNOIQTKYYULGVOKIKUL'VGVKX8KZ[XTZUZNKVXK\OU[YOTZKXLGIK
+TZKXZNKSKT[$9KZ5XOMOTZU9KZZNKI[XXKTZIUUXJOTGZKGYZNK
5XOMOTULVXUIKYYOTM
+TZKXZNKSKT[6XOTZLXUS9*$)4))XG\OTM:KYZ3UJRKMIUJKYKRKIZ
ZNKLORKGTJIROIQ6XOTZ
=GOZLUXLOTOYN6RKGYK]KGXYGLKZ_MRGYYKY]NKTUHYKX\KZNKVXUIKYYOTM
8KRG^ZNKZN[SHYIXK]GTJZGQKZNKSUJKR
Tip:

Loosen the meter screw at the lower end of the coupling on the CNC
Toolhead, load the new Toolhead and tighten the meter screw. It is
recommended to use the special cutter for this product.

Start using CNC Toolhead when printing. Set Origin, the central point in


must be tightened, otherwise accidents may occur.
--------

(+I[H3GQKX:5?*/?HGYOIYKZ[VGTJOTYZGRRGZOUT

------------------------------------------------------------------------------------------------------------------------------------------